First, the plastic suite factor
The plastic kit is an important part of the composition of the display fireproof raw material. Since it is mainly used for the use of the element board module cover, it is a PC + fiberglass material with flame retardant function. It not only has a flame retardant function, but also in high and low temperature and long-term use, there will be no deformation, brittle and cracking and so on. At the same time it uses a better seal of the glue, can effectively block the external environment of the rain into the internal, so as to avoid short-circuit caused by the fire situation.
Second, the wire factor
The larger the display area of the display area, the greater the amount of electricity used, then the power requirements of the wire is also higher. In many wire products, only the use of wire in line with the requirements of the national standard to ensure its safety and stability. In the selection must meet these requirements: First, the core must be copper wire conductive carrier. Second, the core cross-sectional area tolerance within the standard range. Finally, wrapped wire core rubber insulation and flame resistance to achieve the standard.
Third, the power factor
In the choice of power products, only through the UL certified power products is the best choice. Because of its effective conversion rate to ensure that the power load is safe and stable, so the external environment in the case of hot, but also work properly.