LED lights and incandescent lamp contrast

Jul 18, 2017

Leave a message

LED lights and incandescent contrast:

1, led lights in the AC drive and ordinary incandescent lamps will have the same phenomenon, and ordinary energy-saving lamps do not strobe phenomenon. Stimulation makes the eyes easy to fatigue.

2, each led light bulb is too bright, will be strong to stimulate the eyes, can not look directly, even a short time, and ordinary energy-saving lamps are relatively soft!

3, the angle of exposure is limited, generally only 120 ° irradiation, and ordinary energy-saving lamps can only be irradiated 360 °.

4, the brightness of the room is not better than the energy-saving lamps, because the direct view only in the narrow angle of high brightness, and from the angle after the rapid decline in light.

Therefore, led energy-saving lamps as the advantages of indoor lighting may not be more than ordinary energy-saving lamps, but as a flashlight, table lamps, spotlights and so on only need to illuminate a small angle when the use of lamps is still very good.

 How to buy LED lights:

1, LED brightness (MCD) is different, the price is different. LED for led lamps should comply with laser class Ⅰ standard.

2, anti-static ability Antistatic ability LED, long life, and thus high prices. Usually anti-static greater than 700V LED can be used for LED lighting.

3, the same wavelength of the LED, the same color, such as the requirements of the same color, the price is high. Producers who do not have LED spectrophotograms are hard to produce purely color products.

4, leakage current LED is a one-way conductive light, if there is reverse current, known as leakage, leakage current LED, short life, low prices.

5, the use of different angles LED light angle is not the same. Special light angle, the price is higher. Such as full diffuse angle, the price is higher.

6, the quality of life is the key to the quality of life, life by the decay of light. Light fades small, long life, long life, high prices.

7, wafer LED luminous body for the wafer, different chips, the price difference is very large. Japan, the United States of the chip more expensive, generally Taiwan and domestic chip prices lower than Japan, the United States (CREE).

8, the size of the chip chip size to the side length, large chip LED quality is better than the small chip. The price is proportional to the size of the chip.

9, colloidal colloidal LED colloid is generally an epoxy resin, plus anti-ultraviolet and fire retardant LED more expensive, high-quality outdoor LED lighting should be anti-ultraviolet and fire. Each product will have a different design, different designs for different purposes, LED lighting reliability design includes: electrical safety, fire safety, environmental safety, mechanical safety, health and safety, safe use of time and other factors. From the electrical safety point of view, should be consistent with the relevant international and national standards.