LED display scanning mode and the basic working principle

Jul 14, 2017

Leave a message

With the development of LED technology, LED electronic display brightness also will continue to increase, and the size is getting smaller and smaller, which shows that more LED electronic display into the room will become the trend of the times. However, due to LED brightness and pixel density to the LED screen control and drive also brings new higher requirements. On the general indoor screen, the common control methods are used in the ranks of sub-control mode, which is commonly referred to as the scanning mode, LED electronic display for the current mode of static scanning and dynamic scanning of two, static scanning For static real pixels and static virtual, dynamic scanning is also divided into dynamic real and dynamic virtual.

    In the LED electronic display, the number of lines at the same time and the proportion of the total number of rows, said scanning method. The scanning is also divided into 1/2 sweep, 1/4 sweep, 1/8 sweep, 1/16 sweep and several other driving methods. In other words, the display of the drive is not the same way, then the settings on the receiving card is not the same. If the receiving card is originally used in the 1/4 scan screen, and now used in the static screen, then the display will be displayed on the line 4 lines. General receiving card can be set, connect the good send card, display, computer and other major devices, you can enter the relevant software on the computer to set. Then here to introduce the LED electronic display scan mode and principle.

First, LED electronic display scanning:

    1, dynamic scanning: dynamic scanning is from the driver IC output to the pixels between the implementation of the "point to column" control, dynamic scanning requires control circuit, the cost is lower than the static scan, but the display is poor, the greater the loss of brightness The

    2, static scan: static scan is from the driver IC output to the pixels between the implementation of "point to point" control, static scan does not require control circuit, the cost is higher than the dynamic scan, but the display is good, good stability, loss of brightness Smaller and so on.

    Second, LED electronic display 1/4 scan mode works:

    Is in a frame of each line within the power supply V1-V4 according to the control requirements of the open time of 1/4. The advantage of this is that you can make more efficient use of LED display features and reduce hardware costs. The disadvantage is that in a frame image, each line of LED can only display a quarter of the time.

    Third, according to LED electronic display type Scanning method classification:

    1, indoor full color LED electronic display scanning: P4, P5 constant current 1/16, P6, P7.62 constant current 1/8.

    2, outdoor full color LED electronic display scanning: P10, P12 for the constant current 1/2, 1/4, P16, P20, P25 is static.

    3, single and double color LED electronic display scanning is mainly constant current 1/4, constant current 1/8 sweep, constant current 1/16 sweep.