
Want to understand how the LED display is working, first of all to clear the LED display a variety of signal trends, and secondly to further understand the LED display works. LED display there are five kinds of signals, the coordination of these signals to complete the data transmission, display work.
LED display by the data acquisition system, control system, and display system composed of three parts. Data signals for: peripherals - computer - DVI graphics - data transmission card - data receiving card - HUB adapter board - display.
The actual situation is, HUB adapter board as the last part of the data transmission, all the signals can be HUB adapter board to find. HUB adapter board is the signal issued by the control panel is divided into several tributaries of the card board, also known as the sub-line board. Under normal circumstances, according to the LED electronic screen itself, the number of longitudinal components determined.
The display contains a variety of signals. Signal from the HUB board, through the cable connected to the cell board or module, to complete the data transmission. In addition to the data signal is serial transmission, the other signals are parallel transmission. Now the various signal effects are analyzed as follows.
CLK clock signal: shift pulse provided to the shift register, each pulse will cause the data to move in or out of a bit. Data on the data port must be coordinated with the clock signal to normally transmit data, the frequency of the data signal must be 1/2 of the frequency of the clock signal. In any case, when the clock signal is abnormal, will make the whole board display chaotic.
STB Latch signal: When all the data transmission is completed, the STB latch signal is valid, the data in the shift register is latched, and its data content is displayed by driving the LED.
However, since the drive circuit is controlled by the EN enable signal, its lighting condition must be enabled. The latch signal also needs to be coordinated with the clock signal to show the complete picture. In any case, when the latch signal is abnormal, will make the whole board display chaotic.
EN enable signal: full screen brightness control signal, also used for display blanking. As long as the adjustment of its duty cycle can control the brightness changes. When the enable signal is abnormal, the entire screen will appear off, dark or smear and so on.
Color data signal: Provides the data needed to display the image. Must be coordinated with the clock signal to transfer the data to any of the display points. Usually in the display in the red, green and blue data signal separation, if a data signal short to the positive or negative, the corresponding color will appear full or not bright, when the data signal is floating when the corresponding color display The situation is uncertain.
