Are the LED display wicks green and yellow?
Researchers in Saudi Arabia's King Abdullah University of Science and Technology; KAUST and the old king Technology City (King Abdulaziz City for) have proposed a novel method to fill the common cause of conversion in white light applications based on multi phosphor powder. Green-yellow gap caused by poor efficiency.

20161101 LED NT01P3 uses two temperature step growth method for component structure SEM diagram.
In the research paper published in the Journal ACS Photonics, "True Yellow Light-Emitting Diodes as Phosphor for Tunable Color-Rendering Index), describes a nanometer line that is launched, which can be compatible with the low cost titanium film / silicon substrate compatible with the process. Growth on the platform. The dense nanowire layer can grow to a surface density of 9x109 cm^2 with a filling factor of 88%.

The LED NT01P2 component structure shows the side-by-side growth of the nanowire line.
Each nanowire p-i-n LED structure is embedded in an active region of a 5 layer 3nm thick InGaN quantum disk (Qdisk) stack, separated by each layer and separated from the 10nm quantum barrier layer.
At the single operation of the Yellow nanowire LED, the researchers observed the peak emission of 588nm and the low conduction voltage of about 2.5V at 29.5 A/cm^2 (about 75mA on the 0.5x0.5mm^2 component), and the internal quantum efficiency was about 39%, and before the injection density of 29.5A/cm^2, it was not in the case of "efficiency reduction".
Next, researchers showed the benefits of mixing yellow and red, green and blue laser diodes. In the actual setting, the RGB beam is used to irradiate the Yellow nanowire LED, like the phosphor, and the light scattering layer is used in the reflection configuration, and the yellow light emission is added to the white light mixture.
The result is about 6000K related color temperature and a color rendering index of 87.7.

LED NT01P1 yellow nanowire LED
The aim of this approach is to reduce the blue light intensity in the white light to create a warmer white light for the human eye, and to provide a new method for tuning the color temperature for the laser based solid-state lighting (SSL), says Boon S. Ooi, director of the KACST solid lighting technology innovation center and Professor of electronic engineering. "At present, we have patented this technology," which hints at some business opportunities in the future.
