Just touch the LED electronic display, half will feel no way to start, groping for half a day can not find the correct installation method, and sometimes even find LED electronic display installation method can not put hands and feet to get. Therefore, the following for everyone to summarize the full color led display installation steps.
LED electronic display installation hardware steps:
1, the DVI graphics card into the motherboard AGP jack, then the driver set up;
2, the data card into the motherboard PDI socket (this is a data card users);
3, will be installed above the two controls DVI and AGP link together;
4, the control line and serial port Rs232 connected;
5, with the network cable and the receiving card connected; specific number according to engineering drawings;
6, check the connection can be set to correct or power debugging.
Full color led display software device
The device is as follows:
1, graphics driver installed
The graphics driver CD into the CD-ROM drive, you can automatically enter the device status, please follow the prompts can be;
First install DirectX8.1 and then install the driver; the last device control panel.
2, play the software
Device large screen dedicated play and set software LED studio, or other control software;
Insert the application software CD with the screen into the CD-ROM drive, copy or install all the order to the computer.
3, after the completion of debugging led electronic display installed successfully
Other Precautions:
Check whether the wiring is correct, including the connection of the strong part (the weak part has been completed in the production enterprise test), the signal connection is correct, mainly for the system to receive the card input and output direction is correct, the direction of the card on the receiving card.
System connection is correct (please refer to the system connection instructions)
Computer software part of the installation is complete, including the graphics card settings (please read the graphics set instructions) and control software installation.
Precautions
1, follow the "user manual" in the operating procedures;
2, moisture, humidity requirements: the maximum operating temperature, LED display should be less than the relative humidity of 92%
3, the temperature is appropriate, the temperature requirements are: working environment temperature -20? C ≤ t ≤ 80? C
Storage ambient temperature -40 ° C ≤ t ≤ 60 ° C
4, power supply to meet the requirements
LED display power supply voltage: 220V? 10% Frequency: 50HZ? 5%
Safe earth contact reliable, ground and zero line isolation reliable, access to power away from high-power electrical equipment.