How The LED Display is Refurbished
A LED screen used for more than 5 years, screen screen is very flower, will you direct this screen to scrap processing? If your warehouse has some idle box, but the area is not big enough to sell, how can you deal with it? If you have bought different batches of the rental box, together with color difference, what do you do?
LED display displays different degrees of flower screen and mosaic in a period of time and time. This is due to the different attenuation curves of the LED lamp. By the point by point correction technique, the brightness of the different light points of the LED display can be effectively adjusted to the same level, so that the LED display can be restored to the perfect display effect, and we can also In order to turn this process into a new LED display screen.
Here we choose a LED display which uses more than 5 years to refurbish. First, the bad module and the blind point are repaired. Then the brightness data of the LED display are collected by the ultra high precision point by point correction device, then the luminance data is analyzed by the point by point correction software, and the corrected data are written to the control data. System system.


After this series of processes, it turned out that the color difference was very serious, the LED screen became very beautiful at the moment, as if you had bought a new LED display, was it very surprising? Many LED display users did not understand the point by point correction technology, causing a lot of available LED displays to be laid off in advance, regardless of the LED display. Screen scrap or recycling needs great investment, and the emergence of point by point correction technology happens to allow the vast number of LED display users to realize the tiny input, high return, and the corrected LED display can continue to use, which is also a measure of low carbon environmental protection.
Why does the LED display need to be refurbished?
Due to the characteristics of the LED luminescent chip and the cause of manufacturing technology, the uniformity of the lamp point of the LED screen is a problem that is difficult to solve in the industry. More because of the discrete type of the chip aging, many LED displays, even for half a year, show serious spots, color blocks, mosaic and other "flower screen" phenomena.
What kind of LED display can be refurbished?
Of course, not all LED screens can be refurbished by point by point correction, such as large area dead light, power failure and other problems caused by the screen can not be lit normally, if those problems, it is necessary to fix the fault points before the old screen refurbishment.
How can the LED display be refurbished?

To refurbish the old screen, it is necessary to repair the fault point first, clean the whole screen, ensure that the LED display is in the best state, and then start a point by point correction. Point by point correction is to use optical instruments to collect the luminance (or chromaticity) data of each lamp of the LED display screen, through the correction software to carry out scientific analysis and calculation, and write the corrected data into the control system to achieve the unified process of the brightness (chromaticity) of the LED display.
The corrected LED display can be kept in 3% of the brightness difference, the chroma difference is within 0.003, the corrected LED display can see the obvious improvement effect, and of course, it will also face a certain degree of brightness loss, which depends on the quality of the LED display.
Notice of LED display after refurbishment
After all, it is refurbished, certainly no new quality is good, the display in the outside of the sun for so long after the refurbishment of life will be affected, light decline faster, the dead light rate increases. What's more, special attention should be paid to some bad businesses who use refurbished displays as new screens.
