Common problems and solutions of luminous words on LED display screen
1. Short service life of LED: The theoretical service life of LED produced by regular manufacturers is about 80000 hours. But now a lot of light-emitting words began to change the LED module frequently in less than a year, which brought a lot of trouble and economic losses to customers and advertisers.
Solution: Purchase qualified LED single lamp produced by a regular manufacturer (quality parameters provided by the manufacturer are required), make their own module. In the electronic display market, we must not buy cheap LED single light bulbs or already made modules. If you need to buy a module, you should see clearly that the module installed several resistors, installation of a resistance module is best not to use. Resistance in the module is a current limiting function, it is easy to heat. For a long time, once the resistor is burnt out, the module will not shine. LED lights usually don't go bad. Do not throw the module away, just replace a resistor with the same resistance and use it normally. This saves money for the production unit. In order to reduce trouble and save money, it is best to choose two modules with resistance. In addition, the production facilities of the supplier who makes the module should be understood to see if the anti-static facilities are used in the module. If there is no additional anti-static facilities, even if the resistance is not burned out in use, LED lights are easily damaged by breakdown.
2. Color fades very fast: just installed light-emitting words emit pure and bright color, can use less than a year on the color pale down obviously. It makes the font red, green, and green.
Solution: LED lamp safe use current is generally 20 mA, exceeding this value, although brightness will increase a little, but the color fading will be significantly accelerated. Therefore, when purchasing the assembled LED module, we must test its output current value. Less than 20 mA, the brightness is not enough, more than 22 milli ampere affects the life of LED, and makes the color decay faster.
3, uneven color, color difference is obvious: mainly in pure white LED produced larger volume of light-emitting characters. In the assembly of a single module performance is not obvious, the whole font assembly is complete, the color difference is clearly shown, the whole literal like a map, a white, a blue, a yellow.
Solution: White LED lights have to go through before the factory spectroscopic color separation (without spectroscopic color separation LED light is pure white, some blue, some yellow), spectroscopic colorimeter expensive, general small factories do not have this kind of equipment, so the production of white light is generally taken to large factories for spectroscopic color separation, because It is not a product of one's own factory, so the color separation will not be so careful. Some small factories simply do not separate colors from each other. They usually pull customers at low prices. So do not buy white LED blindly covet cheap, must buy the same manufacturer, the same batch, the same color LED light-emitting tube single particle lamp or module to produce the same batch of light-emitting words.
4. Some strokes of the font, the whole suddenly not bright or when the light is not bright: after a period of time, the light source of the whole or part of the font will start to shine, when the light is not bright, until completely not bright. Most of the light-emitting modules currently sold on the market are connected by plug connections. In this way, advertising producers are quick and convenient when installing light-emitting modules. But there are also some new problems, because the plug in the long-term use process of moisture erosion in the air easily lead to poor contact, so that part or all of the circuit instantaneous power off or completely power off, resulting in the font light source flashing or not bright.
Solution: a. When making the module, no plug-in is needed, and the copper tin-plated wire is directly connected and soldered with activated carbon. B, the use of artificial agate to make a fully enclosed hollow three-dimensional luminous characters, to isolate the light and air contact.
5, font output power is large, energy saving and energy saving is not obvious.
Solution: Try to use a five-light LED module, so that the number of lights does not change, and power is reduced by two-fifths.

