In the use of full-color LED display device in the process, it is inevitable that sometimes encounter fault problems. Today, we will introduce how to distinguish and judge the full color led display fault diagnosis method.
Step 1: Check the graphics settings section is set up, according to the need to set the method in the CD-ROM electronic file, please consult.
Step 2: Check the system basic connection, such as DVI cable, network cable socket is correct, the main control card and the computer PCI plug connection, serial line connection, connection method has a legend, please carefully refer to reference
Step 3: Check whether the computer and LED power supply system to meet the needs. When the led screen power is insufficient, when the display is close to the white (power consumption) will cause the screen flashes, according to the cabinet power supply needs to prepare the appropriate power supply.
Step 4: Check whether the green light of the sending card is flashing, flashing turn to step 6, if it does not blink, restart, not into the win98 / 2k / xp before checking whether the green light flashing, such as flash to the second step, Please check whether the DVI cable connection is connected, if the problem is not resolved for the sending card, video card and DV line I one of the three is faulty, please replace the third step after the replacement.
Step 5: Please follow the instructions in the software to set or re-install and then set until the send card green light flashes, or repeat step 3.
Step 6: Check if the green light (data light) of the receiving card is blinking with the sending card green light. If it is flashing, go to step 8 and check whether the red light (power) is on. If it turns on, go to step 7, Protection) is bright, if not light Check whether the power supply is reversed or no power output, such as light Check the power supply voltage is 5V, such as turn off the power, remove the adapter and cable try again, if the problem is not resolved for the receiving card failure , Replace the receiving card, repeat step 6.
Step 7: Check whether the cable is connected well or too long (must use the standard super-5 cable, no repeaters of the longest line of small and 100 meters), check the network cable is produced according to the standard (please check the system installation and setup ), If the problem is not resolved for the receiving card failure, replace the receiving card, repeat step 6.
Step 8: Check whether the large-screen power light is on, if not turn on step 7, check whether the adapter card definition line matching with the cell board. Note: Most of the screen body connected, there may be a local box without a picture or Huaping, because the cable RJ45 interface is not strong, or the receiving card power is not connected, resulting in the signal did not pass over, so please re-plug Cable (or swap), or plug in the receiving card power (attention direction) can solve the problem.
