Product application knowledge and performance testing are as follows:
(1) soldering iron: soldering iron (up to 30W) tip temperature does not exceed 300 ℃; welding time of not more than 3 seconds; welding position at least 2 mm from the colloid.
(2) dip welding: dip welding maximum temperature of 260 ℃; dip welding time of not more than 5 seconds; dip welding position at least 2 mm from the colloid.
Pin forming method:
(1) must be 2 mm from the colloid to bend the bracket.
(2) stent forming must be done with a fixture or by a professional.
(3) The stent forming must be completed before welding.
(4) bracket forming to ensure that the pin and spacing on the same line.
LED installation method
(1) pay attention to the arrangement of various devices outside the line, to prevent the polarity of the wrong. The device can not be too close to the heating element, the working conditions do not exceed its specified limit.
(2) Be sure not to install LEDs when the pins are deformed.
(3) When determining the installation in the hole, calculate the size and tolerances of the faces and the pitch on the circuit board to avoid excessive pressure on the stand.
(4) when the installation of LED, built with guide sleeve positioning.
(5) Before the welding temperature returns to normal, the LED must be protected from any vibration or external force.
Cleaning
Care must be taken when cleaning colloids with chemicals, as some chemicals are damaged on colloidal surfaces and cause discoloration such as trichlorethylene, acetone, and the like. Can be wiped with ethanol, impregnated, the time at room temperature no more than 3 minutes.
Working and Storage Temperature:
(1) LED LAMPS light-emitting diode Topr-25 ℃ ~ 85 ℃, Tstg-40 ℃ ~ 100 ℃
(2) LED DISPLAYS monitor Topr-20 ℃ ~ 70 ℃, Tstg-20 ℃ ~ 85 ℃
(3) OUT-DOOR LED LAMPS pixel tube Topr-20 ℃ ~ 60 ℃, Tstg-20 ℃ ~ 70 ℃